Customized Special T Type Carbide Burrs Middle Cut Long Shank
Length Big Size Burrs
What Carbide Burr Tool RPM speed should you use?
The speed at which you use your carbide burr in your rotary tool
will depend on the material you’re using it on and the contour
being produced but it’s safe to say you do not need more than
35,000 RPM. If the burs are chipping easily this could be due to
the speed being too slow. It’s ideal to start the bur off slow,
increasing the speed as you go along. High speeds will prevent
clogging in the flutes of your carbide burs.
As with all drill bits and burrs, let the burr do the work and
apply only a little pressure, otherwise the cutting edges of the
flutes will chip away or become smooth too quickly, reducing the
life of your burr.
Our carbide burrs we manufacture are machine ground from a
specially chosen grade of carbide. Due to the extreme hardness of
the tungsten carbide, they can be used on much more demanding jobs
than HSS (High Speed Steel). Carbide Burrs also perform better at
higher temperatures than HSS, so you can run them hotter, and for
longer. HSS burrs will start to soften at higher temperatures, so
carbide is always a better choice for long term performance.
Single Cut Carbide Burr Cutting Tools
Single cut is a general purpose tool designed for cast iron, steel,
some copper and brass and other ferrous materials. It will give
good material removal and good workpiece finishes.
Double Cut Carbide Burr Cutting Tools
Double cut allows for rapid stock removal in harder materials. The
addition of the left hand flutes reduce the pulling action,
allowing better operator control. It reduces the size of the chips
and can be used at slower than normal speeds.
Non-Ferrous Aluminum Cut Carbide Burrs
Non-ferrous are exactly what you would expect them to be. They are
specially designed to be used on non-ferrous materials such as
aluminum, copper and magnesium.
